First Kit DONE!

Fiberglass work was actually pretty interesting and fun. I was a little bit afraid of how it was going to work, but I feel the results are good. I started by trimming the horizontal stabilizer tips and filling the rear part of them. Now after it is done, I feel I could have created a narrower gap between the tips and elevators.

Fitting the elevator and rudder tips was pretty simple. I used my heat gun to adjust them on some places, and a little bit more may be required once all parts come together on the airplane as I saw some minor misalignment once I riveted them in place.

The last piece I worked on was the rudder bottom piece. I decided to go with the flyleds DIY nav/led/landing lights kit. As a result I just bought the tailight/ strobe and fitted it in place. I also used epoxy to secure the support inside the fairing. The last thing I did was add extra fabric and epoxy inside at the join line between the too halves of each fiberglass tip fairing for a little more support.

The final result:

img_7591

 

Rudder – 1

I started working on the rudder right after finishing the HS. It has been pretty straight forward until now. The first step was to trim and prepare the stiffeners. It is pretty awesome to see how the pre-punched holes only align in a specific way. It makes it really easy to get it right even for me:). Back riveting is the easiest way of getting good results no doubt about it!.

Once I had both skins ready I started to work on the structure. It took me a little bit of time to totally understand how the bottom part of the rudder goes together. Once I got it, preparation is basically the same that I’ve been doing on previous parts.

I’m done to the point where I have to start riveting the trailing edge. I bonded it with T-88 epoxy as mentioned on the instructions. I’ve been waiting for it to cure a couple of days, while I also order some rivets and an extra bucking bar to reach some pretty tight places near the trailing edge.

Last Friday I met another builder, Paul, who came from Cleburne, TX to check on my project. We had a pretty cool conversation sharing ideas and experiences. I hope to be down there visiting him pretty soon. If you want to check his work, he has a pretty cool builders blog here!.